```  G0 X[#<x_center_probed>] Y[#<y_center_probed>]

  o<140> if [#<cal_diameter> GT #<x_probed_width>]
    (calculate calibration error and adjust calibration offset)
    #<x_cal_error> = [[#<cal_diameter> - #<x_probed_width>] / 2]
    #<new_x_cal_offset> = [#<x_cal_error> - #<calibration_offset>]
  o<140> else
    #<x_cal_error> = [[#<x_probed_width> - #<cal_diameter>] / 2]
    #<new_x_cal_offset> = [#<calibration_offset> + #<x_cal_error>]
  o<140> endif