> <@marijns95:matrix.org> This * So I tested the 1:1:1 topology on rc and it looks better than before now. I don't see any errors related to panel at all, and hwtest gives me ``` Category Model Path Status Value framebuffer msmdrmfb /sys/class/graphics/fb0 working U:1080x2400p-0 drm - /sys/class/drm/card0-DSI-1 working 1080x2400 input pmic_pwrkey /dev/input/event0 working input pmic_resin /dev/input/event1 working input gpio-keys /dev/input/event2 working ``` So far, so good. Panel however isn't outputting anything. But when I do `cat /sys/class/backlight/ae94000.dsi.0/actual_brightness`, I start seeing errors in dmesg: ``` [ 546.207426] [drm:dpu_encoder_frame_done_timeout:2339] [dpu error]enc31 frame done timeout [ 546.262665] dsi_cmds2buf_tx: cmd dma tx failed, type=0x6, data0=0x52, len=4, ret=-110 [ 546.262689] msm_dsi_host_cmd_rx: Read cmd Tx failed, -110 [ 546.411818] [drm:_dpu_encoder_phys_cmd_wait_for_idle] *ERROR* id:31 pp:0 kickoff timeout 2 cnt 1 koff_cnt 1 [ 546.411926] [drm:dpu_encoder_phys_cmd_prepare_for_kickoff] *ERROR* failed wait_for_idle: id:31 ret:-110 pp:0 [ 546.467857] dsi_cmds2buf_tx: cmd dma tx failed, type=0x37, data0=0x2, len=4, ret=-110 [ 546.467892] msm_dsi_host_cmd_rx: Set max pkt size failed, -110 [ 546.496772] [drm:dpu_encoder_frame_done_timeout:2339] [dpu error]enc31 frame done timeout [ 546.615949] [drm:dpu_encoder_phys_cmd_prepare_for_kickoff] *ERROR* failed wait_for_idle: id:31 ret:-110 pp:0 ... [ 548.253245] [drm:dpu_crtc_frame_event_work:660] [dpu error]crtc81 ts:548251280935 received panel dead event ``` the last part just keeps repeating and is fairly familiar now, that's the one I always got.